FAN35T Operating & Remote Functions Guide

• Click Here For Installation and Pairing with FAN30R
• Click Here For Pairing with Basic Receivers/ Dip Switches
• Click Here For Installing Basic Dip Switch Receivers

• Install 23A 12-volt battery. (To prevent damage to the transmitter, remove the battery if not used for a long time).
• Store the transmitter away from excessive heat or humidity.
• This remote control unit is equipped with 16 code combinations. To prevent possible interference from or to other remote units such as garage door openers, car alarms, or security systems. If your fan and light kit go on and off without using your remote control, change the code combination in your transmitter.

Basic Button Functions

Operating the buttons on the panel of the transmitter. 

• [III] key for fan high speed. 
• [II] key for fan medium speed. 
• [I] key for fan low speed. 
• [O] key-for fan off. 
• [LIGHT] key for light brightness.

Dimming and Light Functions

The light function is controlled by pressing the [LIGHT] key down to increase or decrease light. Tap the key quickly to turn the light off or on. Keep pressing the button over 0.7 seconds, and it becomes a dimmer; the light varies cyclically in 0.8 seconds. The receiver can remember the last status of the light brightness when the light is switched so that it can resume to adjust the light brightness.