Anderic FAN30R and FAN35T Installation Instructions/User Guide
Aydan
Last Update hace 3 meses
Pairing Instructions for FAN35T to FAN30R using the Learning button
1. Setting the code on the remote
A. Remove the battery cover.
B. Slide the code switches to your choice of up or down position (factory setting is all up).
Do not use this position. Use a small screwdriver or a ballpoint pen to slide firmly up or down
2. Setting the code on the receiver (Fig. 3):
A. Turn the fan's power off.
B. Return power to the fan.
C. Within 30 seconds of returning power to the fan, hold the LEARN key for a minimum of 3 seconds. The light on the front of the remote should blink twice to confirm the code was learned to the receiver.
3. Place the battery cover on the remote.
Operating the Fan35T
Installing the FAN30R receiver
- Remove the Motor housing on your ceiling fan
- Unscrew the receiver and unplug the nine-pin plug
- Place FAN30R above motor
- Plug in nine pin on the FAN30R
- Screw down FAN30R to secure Receiver
