[User Guide] Anderic UC7058GM Ceiling Fan Receiver for Miramar Installation Instructions
Andy Williard
Last Update vor 2 Monaten
Notes
The Anderic UC7058GM ceiling fan receiver may not work with your existing remote. If you need a compatible remote for this receiver, please purchase the Anderic® RR7080T remote control.
Installation instructions:
- Turn the power off to the fan from the circuit breaker box.
- Remove the screws from the receiver cover (located on top of the motor housing).
- Remove any zip ties holding down the wires.
- Loosen the screw holding down the clip which holds the power wires and antenna wire (if necessary).
- Use plyers to remove the crimps holding the receiver's blue and white wires.
- Disconnect the 9-pin connector.
- Remove the two screws holding down the receiver.
- Install the new receiver using the same steps above in reverse order. Use wire nuts to connect the blue and white wires from the receiver to the blue and white wires from the fan.
Pairing with remote:
Note: This unit has a total of 16 different code combinations using the four dip-switches located in the remote and on the receiver.
- On the remote: Remove the battery cover and set the dip switches to any pattern.
- On the receiver: Set the dip-switches to the same pattern as the remote. See the diagram below.