[User Guide] Anderic UC7058RY UC7058YM-01 For Windward II Ceiling Fan Receiver Installation Instructions

The Anderic UC7058RY ceiling fan receiver for Windward II ceiling fans is designed to replace your existing Windward II ceiling fan receiver. See the below additional parts that may be required. 

• Optional remote: Anderic RR7078TR Ceiling Fan remote control
• 2nd optional remote: Anderic RR7083TR Ceiling Fan remote control
• Molex to Amp adapter ceiling fan cable

1. Turn the power off to the fan from the circuit breaker box.
2. Remove the screws from the receiver cover (located on top of the motor housing).
3. Remove any zip ties holding down the wires.
4. Loosen the screw holding down the clip which holds the power wires and antenna wire (if necessary).
5. Use plyers to remove the crimps holding the receiver's blue and white wires.
6. Disconnect the 9-pin connector.
7. Remove the two screws holding down the receiver.
8. Install the new receiver using the same steps above in reverse order. Use wire nuts to connect the blue and white wires from the receiver to the blue and white wires from the fan.

1. On the remote: Remove the battery cover and set the dip switches to any pattern.
2. On the receiver: Set the dip-switches to the same pattern as the remote. See the diagram below.