[User Guide]Anderic RRAV498 User and Programming Guide

• Pre-programmed for Yamaha receivers—no setup required.

• Designed as a direct replacement for the original Yamaha RAV498 remote.

• Includes an instruction manual for easy use.

• Can be programmed to control other devices such as TVs, DVD players, and satellite receivers.

• Guaranteed compatibility with select Yamaha receivers (refer to the “Used with Models” section for details).

• See the code list section of your user manual to find the corresponding code depending on the brand of the device you want to register.
  • Register the first code in the list if there are multiple remote control codes. If that does not work, try the other codes.
• Press the [CODE SET] key using a pointed object, such as the tip of a ballpoint pen.
  • SOURCE/RECEIVER blinks twice.
  • Perform each of the following steps within one minute. Otherwise, the setting will be canceled. If this happens, repeat from step two.
• Press the input selection key.
  • For example, press the HDMI 1 to set the remote control code for the playback device connected to the HDMI 1 jack. 4.
  • Use the numeric keys to enter the 4-digit remote control code.
  • Once the remote control code is registered successfully, SOURCE/RECEIVER blinks twice.
  • If it blinks six times, registration has failed. Repeat Step Two.

• You can reset a remote control code registered to each input selection key.
• Press the [CODE SET] key using a pointed object, such as the tip of a ballpoint pen.
  • • SOURCE/RECEIVER Blinks twice
    • Perform each of the following steps within one minute. Otherwise, the setting will be canceled. If this happens, repeat from step one.
  • Press the input selection key you wish to reset.
  • Use the numeric keys to enter “5098”. Once the remote control code is reset successfully, SOURCE/RECEIVER blinks twice. If it blinks six times, resetting has failed. Repeat from step one.

• Press the [CODE SET] key using a pointed object, such as the tip of a ballpoint pen.
• Press SOURCE/RECEIVER.
• Use the numeric keypad to enter “9981”.

https://www.replacementremotes.com/store/productfiles/RRAV498-CODELIST.pdf