Anderic RRTR292A for Harbor Breeze KUJCE10612 TR292A TRD050G1M 2AQZU18053 Ceiling Fan Remote Control Pairing Instructions

Aydan

Last Update 16 วันที่แล้ว

Learning Process

NOTE: The Hand Held Remote Control System is equipped with a learning frequency function

which has code combinations to prevent potential interference from other remote units

  1. Open the remote battery cover and install DC3V and AAA 2pcs batteries. 
  2. Within 30 seconds of turning the Receiver AC power ON.
  3. Press and hold the remote “LEARN” key for over 5 seconds; once the receiver has detected the frequency, the receiver will make a sound, Bi Bi, twice. This will indicate the receiver has learned the frequency previously selected on the transmitter.

NOTE: After the AC power is on, do not press any other button on the transmitter before setting learning. Doing so will cause the procedure to fail. After completing the steps above, you should be able to operate the ceiling fan and light. If the fan is not responding to the transmitter, please turn the receiver's power off. And repeat steps 1 and 2.
NOTE: Remove the battery if not used for long periods to prevent damage to the handheld remote. 

Functions of The Remote

[Power] To turn the fan on or off. 

[+] Press this button to increase the fan speed, and the LED indicator will be on the position of the fan speed. (1~6 speed) 

[-] Press this button to decrease the fan speed, and the LED indicator will be on the position of the fan speed. (1~6 speed) 

FANTIMER:

[2hr]: Setting up the ceiling fan to turn off automatically after 2 hours. 

[4hr]: Setting up the ceiling fan to turn off automatically after 4 hours. 

[8hr]: Setting up the ceiling fan to turn off automatically after 8 hours. Press the fan speed button to deactivate 

[Person] Tap once to activate. The light on the ceiling fan blinks once to confirm that the Walk Away Delay is active. The light turns off after 1 minute. Press any key to cancel the function.

[Home] HomeShield: Press and hold the button to activate. The light on the ceiling fan blinks two times to confirm that Home Shield is active. The fan remains off, and the light randomly turns on for a minimum of 5 minutes and a maximum of 20 minutes. The light stays off for 60 minutes between events. To deactivate, press any button once.

[≋] Press the button to set the fan speed change automatically. Press Fan Speed to deactivate.

[Light Bulb]: Press to turn on and turn off the light 


NOTE: The LED indicator should be on position one when pressing the remote button. If you press the remote button and the LED indicator is not on, change the new DC3V and AAA 2pcs batteries.

Was this article helpful?

0 out of 0 liked this article

Still need help? Message Us