[User Guide] Anderic 99198 Ceiling Fan Remote Control
Andy Williard
Last Update vor 3 Monaten
Note: The Anderic 99198 ceiling fan remote control requires an installed compatible receiver. The receiver unit installed must read 99199 by Casablanca and Hunter ceiling fans. Please follow the installation instructions included with the receiver before setting up this remote control.
Pairing
Power off the ceiling fan and pre-install the compatible receiver to prepare the receiver for pairing with the remote control.
To access the battery compartment, slide the battery door upwards.
3. Install the batteries.
Install two AAA batteries into the remote control. Reinstall the battery door.
4. Turn power on.
Connect power to the ceiling fan.
5. Pair the remote.
Within three minutes, press the pair button located in the battery compartment. If pairing was successful, a single beep will sound. Replace the battery door.
6. Install the remote controls wall mount bracket.
You have two options for installing the wall mount bracket: you can use screws (sold separately) or adhesive foam double-sided tape (sold separately).
7. Install the holder on the cradle.
Slide the wall mount holder onto the wall mounted cradle by aligning the groves and sliding it down from the top.
Button functions
Legal Information
Anderic is a registered trademark of Dan's Electronics Etc., Inc. Hunter and Casablanca are registered trademarks of their respective companies. Anderic is not affiliated. All rights reserved.