[User Guide] Anderic 99770 Ceiling Fan Remote Control

Please make a note of the following information:

The Anderic 99770 Ceiling Fan Remote Control seamlessly replaces models 99813, 99770, 99732, 99392, KB286, K6132, K6266, K6019, and K5579, ensuring broad compatibility with your existing setup. For optimal performance, ensure your original remote matches one of these models, as this remote is not recommended for other models.

This remote control requires a pre-installed receiver, as the receiver is not included with this replacement unit. This manual does not include instructions for installing the receiver.

1. Turn off the power to the ceiling fan.

Power off the ceiling fan and pre-install the compatible receiver to prepare the receiver for pairing with the remote control.

2. Open the battery compartment.
To access the battery compartment, remove the screw (if inserted), and slide the battery door downwards.

3. Install the batteries.

Install a CR2032 battery into the remote control with the positive side facing up. Reinstall the battery door.

4. Turn power on.

Connect power to the ceiling fan.

5. Pair the remote.

Within three minutes, press the pair button located in the battery compartment. If pairing was successful, a single beep will sound. Replace the battery door.

6. Install the remote controls wall mount bracket.

You have two options for installing the wall mount bracket: you can use screws (sold separately) or adhesive foam double-sided tape (sold separately).

7. Install the holder on the cradle.

Slide the wall mount holder onto the wall mounted cradle by aligning the groves and sliding it down from the top.

Legal Information

Anderic is a registered trademark of Dan's Electronics Etc., Inc. Hunter and Fanimation are registered trademarks of their respective companies. Anderic is not affiliated. All rights reserved.