Anderic RR7096T / RR7096TR / CHQ7096T User and Operating Guide

Note: This unit has 16 code combinations using the four dip switches
located in the remote’s battery compartment and the receiver. 

4-DIP Switch Combination Chart

Anderic UC7067FCRX Installation Guide

1. Remove the battery cover of your remote and set the dip switches to any pattern.

2. Set the dip switches on the receiver to the same pattern as the remote.

See diagram below

Installing the batteries: Insert a set of four (4) AAA 1.5v batteries into the
battery compartment, taking note of the direction of polarity

Fahrenheit to Celsius Toggle:
Using a pen, insert the pointy-end of the pen into the pin-hole located on the back of the remote that reads “F / C,” and quickly press and release the button inside the hole to toggle between settings.

• BLUE FAN KEY – For fan speed control – with each press cycle, the fan speeds from High -> Medium -> Low -> Off 
• FAN AUTO KEY – For setting fan speeds to adjust depending on the temperature you set here. Click the FAN AUTO key, then the TEMP UP/DOWN keys to adjust the
  desired temperature. The fan will now change the speeds according to temperature. 
• Note: The fan will be off if the indoor temperature is lower than the set temperature. If the indoor temperature is 0-2 degrees Celsius warmer than the set temperature: The fan will turn to the low-speed setting. If the indoor temperature is 2-4 degrees Celsius warmer than the set temperature: The fan will turn to the medium-speed setting. If the indoor temperature is greater than 4 degrees Celsius and warmer than the set temperature, the fan will turn to the high-speed setting. 
• TIMER KEY (RR7096T remote only) – Set timer option of FAN or LIGHT HOUR ^ KEY – Have time or temp. UP. 
• HOUR v KEY – Have a timer or temp. DOWN. 
• FAN/REV KEY (RR7096TR remote only) – Will reverse the fan spin direction. 
• LIGHT KEY – Toggles light ON/OFF. Press and hold to cycle dimming. 
• LIGHT DELAY KEY – Turns the light off automatically after 3 minutes.