27

Ceiling Fan User Guides

Last Update há 24 dias

[User Guide] Anderic UC7058RY UC7058YM-01 For Windward II Ceiling Fan Receiver Installation Instructions [User Guide] Anderic UC7058GM Ceiling Fan Receiver for Miramar Installation Instructions [User Guide] Anderic RRTX015 / A25-TX015A Ceiling Fan Remote Control for Harbor Breeze [User Guide] Anderic RRTX001R / A25-TX001-R1 / A25-TX005-R for Harbor Breeze Ceiling Fans [User Guide] Anderic RRTX00I / A25-TX00I / TR258A / KUJCE10512 For Harbor Breeze Ceiling Fan Remote Control

[User Guide] Anderic RRTX007 Ceiling Fan Remote Control - A25-TX007, TX007-LS

Andy Williard

Last Update há 4 meses

Product Features

  • Works for 3-speed fans
  • Light ON/OFF/Dimming
  • Learning Code pairing

Notes

  • To view the product information for this remote control, please go to the Anderic RRTX007 at Anderic.com.
  • The receiver must be installed: This guide does not explain installing the associated receiver unit in your fan. Your fan should already have the compatible receiver installed. If you require a new receiver, we recommend the Anderic 63T-AC83T-KIT.
  • Important Note and Battery Requirement: Please ensure that the back of your original remote reads "A25-TX007" to guarantee compatibility with the ANDERIC RRTX007 replacement remote. It requires a 12V A23 battery, which is sold separately.
  • Frequency and Compatibility: Operating at a frequency of 315MHz, the ANDERIC RRTX007 remote is designed to perfectly replace the Harbor Breeze A25-TX007(R1) model. It is compatible with the following Harbor Breeze remotes: A25-TX007-R1, A25-TX007-N, A25-TX007-L, A25-TX007-S, A25-TX007-LS, and A25-TX007-LR. The RRTX007 remote is known to work with the 00581 STG60 SARATOGA II CEILING FAN and other compatible models.

Pairing Instructions

  1. Install a 12V battery into the remote control, making sure to match polarity.
  2. Move any DIP switch to the position you desire (Fig 2, 7).
  3. Power off the fan either by the wall switch or the circuit breaker. 
  4. Within 30 seconds of restoring power to the fan, Tap the "LEARN" key, located inside the battery compartment (Fig 2, 7).

If successful, the fan will turn to LOW speed, and the light will blink two times, then ON. If the fan does not respond, try pressing the keys on the remote to see if it will operate. If not, try repeating the steps above.

Using the remote (Figure 1 & 2)

(1),(2),(3): Turn on the fan at LOW/MEDIUM/HIGH speed


(4): Turn the fan blades OFF

(5): Light on/off/dimming – tapping the key will toggle the light ON/OFF, and holding the key will cycle dimming brightness

(6): LEARN key: Tap to learn code

(7): DIP switch: Move to select the desired code mode

Installing the wall mount bracket

Find a convenient mounting location. Use two screws to install the wall mount bracket, then slide the small screw cover plate into the slot to hide the screws. 

Anderic® is a registered trademark of Dan’s Electronics Etc., Inc.

Was this article helpful?

0 out of 0 liked this article

Still need help? Message Us