Anderic FAN2R / UC7051R / UC7051G Ceiling Fan Receiver Installation Instructions and Pairing Guide
Andy Williard
Last Update hace 2 meses
This user guide can be used for the Anderic FAN2R, the Anderic UC7051R, and the Anderic UC7051G ceiling fan receivers. Please take a look at the installation instructions below.
Compatibility
The ceiling fan receiver can work with various ceiling fans. This receiver only works with remote controls with the 4-dip switches on the 304MHz frequency. Some remote controls that we recommend to work with this receiver are as follows:
- Anderic RR7078TR ceiling fan remote (FAN2R and UC7051R)
- Anderic RR7083TR ceiling fan remote (FAN2R and UC7051R)
- Anderic RR7080T ceiling fan remote (UC7051G)
Important to remember
-
Please read and save these instructions. Then, please follow any and all instructions and warnings provided in the ceiling fan's installation documentation.
-
Please note that a qualified electrician is recommended for installation.
-
Before working on the remote control receiver or ceiling fan, disconnect the fan from the power source at the wall switch.
Installation Instructions
-
Disassemble the fan housing to expose the old receiver. Refer to ceiling fan instructions for this.
-
Unplug the old receiver and dispose of it.
-
Replace the receiver with the new receiver. See the image below.
If the old receiver used taps or clips, you may break them off so the new receiver will fit.
Plug in the fan's square plug into the receiver, aligning it where the clip makes a connection.
If you have a light kit, plug in the blue and white wires; these should match the color of the cables. Just so you know, if the plugs are wrong and do not fit, feel free to use a wire-cutting tool to snip, strip, and wire-twist nuts to make the connection.
-
Take note of the pattern of the DIP SWITCH panel on the outside of the receiver.
-
Install the housing back according to instructions on the ceiling fan.

Setting the codes
Setting the codes on the remote control
-
Remove the battery cover. Press firmly on the arrow and slide the battery cover off.
-
Adjust the switches by sliding them up or down to your choice of position. The factory setting is all dip-switches in the up position; we recommend using a different combination.
- Align the switches to the same position on your remote control to match the switch pattern on the receiver.

Wiring information

If your original receiver has the AMP connector, you are required to purchase the AMP to Molex adapter cable.
Please take a look at the wiring diagram for the receiver below. I just wanted to let you know that it is only for reference. We would recommend that you purchase the AMP-MOLEX wiring harness if you need to wire each unit individually.
