Anderic RRDYS01 Programming and Operating User Guide

The Anderic RRDYS01/RRDYS01.2 is a versatile universal remote that may require programming using the provided code sheet. Although it doesn't feature a magnetic backing like the original remotes, it offers a host of impressive features.

Please insert two AAA batteries (sold
separately) into the battery compartment behind the battery door on the back of the remote. You may need to remove the screw securing the battery cover. Please make sure to match polarities when installing the batteries. Slide the battery cover down toward the bottom of the remote to remove it, then replace it after installing the batteries. The battery cover screw is optional and is not needed to secure the battery cover to the remote.

Optional security cable (sold separately) This remote has an optional security cable (sold separately) attachment. You can purchase this security cable from Anderic.com/CBL01. Part number: CBL01.

1. Locate your model fan in the
programming chart below. 

2. Press and hold the two keys shown beside your fan model for about 3 seconds. The indicator light will blink twice and release the keys. 

Note: Please refer to the Key Operations Chart to see which keys should operate. If your fan does not serve as expected, you can also try the other codes; there may be a better suited code. The RRDYS01 is a universal remote but may not work on all models of fans.

1. Press and hold the [SET] & o+ keys simultaneously for about 5 seconds; the indicator light will illuminate brighter and remain bright. Release the keys.

2. Point the original remote control head-to-head with the RRDYS01, aligning top edges at about 1-2 inches apart (both remotes should be pointing at each other).

1. On the RRDYS01.2, Press and release the first Key to learn. The indicator light will now flash slowly.

2. On the original remote, press and hold the Key you want to learn to the corresponding Key previously pressed on the RRDYS01.2. The indicator light will flash three times to confirm and then remain on, waiting for the following Key to learn.

3. Repeat steps 2-4 to learn other keys.

4. Press [SET] & Fan- keys simultaneously to save and exit; otherwise remote will exit automatically after 20 seconds.