[User Guide] Anderic RR1DTV 1-Device TV Universal Remote Control
Andy Williard
Last Update 10 months ago
Please remember the following text:
The Anderic RR1DTV remote control is a basic TV-only remote for smart TVs. Please note that this remote is an infrared remote and requires a direct line of sight to operate. It does not have functions such as voice control, cursor, or remote finder.
Please take note of the following text:
Pre-programmed information: Under the default setting, the RR1DTV is pre-programmed using a rolling code technology to work with LG, Samsung, Sony, Philips, Panasonic, and Sharp TVs. However, we recommend programming it using the steps below before use, as the rolling code technology is less responsive.
How to set up your remote (via Code)
- To program your remote, press and hold the MUTE and POWER buttons together for 3 seconds until the LED light comes on, then release the buttons.
- Next, enter the 3-digit TV code from the list below. If you enter the correct code, the LED light will turn off. If the light stays on, the code entered may be incorrect. Please try entering the code again in case of an error.
- After entering the correct code, test the remote functions. If they do not work properly, repeat the steps with a new code.

BRAND | CODES |
LG | 023, 001, 024, 025, 026, 027 |
SAMSUNG | 028, 002, 030, 029, 031, 032 |
SONY | 033, 003, 034 |
PHILIPS | 005, 004, 038, 039, 040, 041, 035, 036, 037 |
PANASONIC | 006, 042, 043, 044 |
SHARP | 045, 007, 046, 047, 048, 049, 050, 058, 057, 056, 055, 054, 053, 052, 051 |
TOSHIBA | 059, 008, 060, 061, 062, 063, 064, 065, 066 |
HITACHI | 009, 067 |
VIZIO | 068, 010, 069, 070, 071, 072 |
TCL | 011, 073, 075, 074, 076 |
JVC | 012, 077, 079, 078, 080, 081 |
HISENSE | 013, 014, 049, 050, 058, 057, 056, 055, 054, 053, 052, 051 |
VESTEL | 015 |
SEIKI | 016 |
SANYO | 017 |
INSIGNIA | 018 |
MAGNAVOX | 021, 035, 036, 037 |
RCA | 019 |
HAIER | 020 |
WESTINGHOUSE | 022 |
Easy One-key programming

- Turn on the TV. Press and hold the button of the corresponding brand for 5 seconds, the LED flashes three times, then the setting is completed.
- Try most keys to see if your TV responds as it should. If not happy with it, try repeating step one, this will update the code to another.

Factory Reset
Hold the OK and 0 keys for about three seconds, the LED will blink four times to confirm.
Additional information
Anderic is a registered trademark of Dan's Electronics Etc., Inc. All rights reserved.