Anderic RRST01 Universal Roku Streaming Player Remote Control - Pairing and Installation Guide

Andy Williard

Last Update sebulan yang lalu

Thank you for purchasing the Anderic RRST01.3 universal remote control. This remote is
programmed to work with Roku® Media Players and LG®/Vizio® TVs (for the keys: ‘Power,’ ‘Mute,’ ‘Vol+/-’). This remote can be programmed to work any TV via the learning method. Please refer to the “Learning Instructions” section for instructions, no codes needed. However, if you have a Roku TV, you can program this remote work via the below table “Programming Codes for Roku TVs.”


NOTE: This remote does not work for Roku Sticks

Installing batteries and the wrist strap

Please see the diagram below. 

  1. Remove the battery cover. 
  2. Insert the batteries, as shown in the diagram below, matching polarities. 
  3. Loop the wrist strap around the screw hole and hold in place while
    replacing the battery cover.

Programming Codes for Roku TVs

Use the codes below to program to Roku TVs 

(TVs manufactured by one of the
brands below with built-in Roku software). 


Steps: 

  1. Take note of the two keys to press from the “Code” column corresponding with your TV brand from the “Brand” column. 
  2. Press & hold the two keys for about 5 seconds until the indicator light flashes three times. It is now programmed. 


Note: If the first code you use does not work, try the other brands as well, one of them will most likely work. 

Learning Instructions

Note: All keys on the RRST01.3 may are learnable. Original remote is needed.
This method does not require codes. 


  1. Press and hold the [HULU] & [OK] keys simultaneously for about 5 seconds; indicator light will illuminate brighter and remain bright. Release the keys. 
  2. Point the original remote control head-to-head with the RRST01.3, aligning top edges at about 1-2 inches apart (both remotes should be pointing at each other). 
  3. On the RRST01.3, press and release the first key to be learned, and the indicator light will flash slowly. 
  4. On the original remote, press and hold the key that you want to learn to the corresponding key previously pressed on the RRST01.3. The indicator light will flash three times to confirm and then remain on, waiting for the following key to learn. 
  5. Repeat steps 2-4 to learn other keys. 
  6. Press the [AMAZON/SLING] & [OK] keys simultaneously to save and exit; otherwise, the remote will exit automatically after 20 seconds. 

Delete all learned keys

  • Press and hold [NETFLIX] & [OK] keys simultaneously for 3 seconds; the indicator
    light will flash three times to confirm. The deletion of all learned keys is now complete.

Reset to factory default status

  • Press and hold the [DISNEY+] & [OK] keys simultaneously for 3 seconds; the
    indicator will flash three times to confirm. Reset to factory default is now complete.

Additional Information

Click below to download the user manual.

Was this article helpful?

0 out of 0 liked this article

Still need help? Message Us